This is probably going to be a pretty short post – it’s a very simple job to do.
My new regulator finally arrived after about a month of waiting, but again, it was $35 instead of the $215 that I was to be charged for buying it locally.
![]() |
Finally arrived! Note Kenny’s artwork. |
Remove the old voltage regulator from beside the battery – use a 10mm socket.
![]() |
Nothing to it, two bolts and a plug and play connector. |
Unplug the six contact connector, and plug the new one in.
Bolt the new regulator to the frame and you’re good to go.
Unfortunately, I didn’t see much different to my battery voltages – either the AGM battery operates at a much lower voltage than I expected, or my problem is elsewhere. We’ll see. At least my setup that allows the ATV to charge off the garage power is still going strong.